ULTRA GEL Nail Extension Gel

Color: violet Consistency: thick The ADORE professional No01 color modeling gel for nails – smoky lavender ULTRA GEL – is a medium–thick gel in vibrant shades designed for nail extension and strengthening of salon length nails. The gel has a medium–density pigment, which does not change color after polymerization. It has medium viscosity and quickly forms a drop when the nail is turned upside down. Highly adhesive. Does not shrink. Odorless. Usage: 1. Modeling on forms (both lower and upper, correction using dust–free techniques. 2. Color strengthening of medium–length natural nails. Application technique: 0. Prepare the nail plate: perform a manicure, shape the free edge of the nail. If using a remover, wipe off its residues with a damp cloth. 1. Degreasing: mechanically (using a buffer) and chemically (using PREPFINISH and a lint–free cloth) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER to the entire nail, allow to air dry until a whitish tint appears on the nail surface. 3. Bonding: using a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, avoiding the cuticle and side walls by 1mm. Let it air dry for 15 seconds. If using MULTI BASE, this step can be skipped. 4. Base coat: apply a thin/working layer of the MULTI/RUBBER BASE cushion base coat. Polymerize the base in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, lay a thin substrate of the desired length and shape directly on the lower or upper template, leaving a 1mm gap from the cuticle, sculpt the nail architecture with the gel to create an arch. You can hold the gel for 7–12 seconds, depending on the type and power of the lamp, then send the nail for complete polymerization of the gel for a minimum of 60 seconds in an LED lamp or for 3–4 minutes in a UV lamp. Remove the sticky residue with PREPFINISH and perform a step–by–step filing of the form, filing the natural nail from the inside by 1mm. 6. Top coat: secure the coating with a top coat. Polymerize in a UV lamp for 2–3 minutes or a LED lamp for 1 minute. If using a top coat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.