ULTRA GEL Extension Gel

Color: Purple Consistency: Thick Color modeling gel for nails ADORE professional No02 – deep purple. ULTRA GEL – a medium–thick gel in vibrant shades for extension and strengthening of salon–length nails. The gel has a dense pigment and does not change color after polymerization. It has medium viscosity and flows quickly into a drop when the nail is turned upside down. Highly adhesive. Does not shrink. Odorless. Usage: 1. Modeling on bottom and top forms, correction without filing technique. 2. Colored strengthening of natural medium–length nails. Application technology: 0. Prepare the nail plate for coating: perform a manicure and shape the free edge of the nail. If using a remover, wipe off any residue with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (using PREPFINISH and a lint–free cloth. 2. Dehydration: apply NAIL FRESHER to the entire nail, let dry in the air until a whitish tint appears on the nail surface. 3. Bonding: using a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, staying 1mm away from the cuticle and side walls. Let dry in the air for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base coat: apply a thin/rubbing layer of the shock–absorbing base coating MULTI/RUBBER BASE. Polymerize the base coating in a UV lamp for 2–3 minutes, in an LED lamp for 60 seconds. 5. Modeling: prepare and position the form alternately on each finger, lay out a thin base of the desired length and shape directly on the lower or top template, leaving 1mm from the cuticle. Model the nail architecture with gel to create an arch; the gel can be adjusted at the 7th–12th second, depending on the type and power of the lamp. Send the nail for full gel polymerization for 90 seconds in an LED lamp or for 3–4 minutes in a UV lamp. Remove the remaining stickiness with PREPFINISH, perform a staged filing to shape, and file the natural nail from the inner side by 1mm. 6. Top coating: secure the coating with a top coat. Polymerize in a UV lamp for 2–3 minutes, in an LED lamp for 1 minute. If using a top coat with a sticky layer RUBBER TOP, let the coating cool, then remove the stickiness with PREPFINISH and a lint–free cloth.