ULTRA GEL Nail Extension Gel

Color: Peach Consistency: Thick Color modeling gel for nails ADORE professional No03 – a gentle peach ULTRA GEL – a medium–thick gel in vibrant shades for nail extension and reinforcement at salon length. The gel features a medium–density pigment that does not change color after polymerization. It has a medium viscosity and drips quickly into a droplet when turning the nail. Highly adhesive. No shrinkage. Odor–free. Usage: 1. Modeling on dual forms and correction with the dust–free technique. 2. Color reinforcement of medium–length natural nails. Application Technology: 0. Prepare the nail plate for coverage: manicure, shape the free edge of the nail. If using a remover, wipe off residues with a damp cloth. 1. Degreasing: mechanically (using a buffer) and chemically (using PREPFINISH and a lint–free cloth) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER to the entire nail, allowing it to air dry until a whitish tint appears on the nail surface. 3. Bonding: with a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, retreating 1mm from the cuticle and sidewalls. Allow to air dry for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base coat: apply a fine/rubbing layer of the cushioned base coat MULTI/RUBBER BASE. Polymerize the base coat in a UV lamp for 2–3 minutes, or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying a thin base of the desired length and shape directly on the lower or upper template, retreating 1mm from the cuticle. Model the nail architecture with the gel to create an arch; you can push the gel at 7–12 seconds, depending on the type and power of the lamp. Send the nail for full gel polymerization for a minimum of 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove the residual stickiness with PREPFINISH and file the natural nail from the inside by 1mm. 6. Top coat: seal with a topcoat. Polymerize in a UV lamp for 2–3 minutes, or in an LED lamp for 1 minute. When using a topcoat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.