ULTRA GEL Nail Extension Gel

Color: turquoise Consistency: thick Color modeling gel for nails ADORE professional No04 – soft mint ULTRA GEL – a medium–thick gel in vibrant shades for building and strengthening salon–length nails. The gel has a medium–density pigment that does not change color after polymerization. It has medium viscosity and quickly pools into a drop when the nail is inverted. Highly adhesive and does not shrink. Odorless. Usage: 1. Sculpting on forms and for correction using the dust–free technique. 2. Colored strengthening of medium–length natural nails. Application technique: 0. Prepare the nail plate for coating: perform a manicure and shape the free edge of the nail. If using a remover, wipe off any residue with a damp cloth. 1. Degreasing: mechanically (using a buffer) and chemically (with PREPFINISH and a lint–free cloth) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER to the entire nail and let it air dry until a whitish hue appears on the nail surface. 3. Bonding: using a semi–dry brush, apply the acid–free primer ULTRABOND to the entire nail, leaving 1mm from the cuticle and sidewalls. Allow it to air dry for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base coat: apply a thin/base layer of the MULTI/RUBBER BASE ground coating and polymerize it in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Sculpting: prepare and place the form alternately on each finger, laying a thin substrate of the desired length and shape directly on the lower or upper template, leaving 1mm from the cuticle. Sculpt the nail architecture with gel to create an arch; you can pinch the gel at 7–12 seconds, depending on the lamp type and power. Send the nail for complete gel polymerization for at least 60 seconds in an LED lamp or for 3–4 minutes in a UV lamp. Remove any residual stickiness with PREPFINISH and file the form, shaping the natural nail from the inside by 1mm. 6. Top coat: secure the top coat. Polymerize in a UV lamp for 2–3 minutes or in an LED lamp for 1 minute. If using a top coat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.