ULTRA GEL Nail Extension Gel

Color: pink Consistency: thick The ADORE professional No05 colored modeling gel for nails is a rich pink–purple ULTRA GEL – a medium–thick gel in vibrant shades for building and strengthening salon–length nails. The gel has a medium–density pigment that does not change color after polymerization. It has moderate viscosity and quickly forms a droplet when the nail is turned upside down. It is highly adhesive, does not shrink, and has no strong odor. Usage: 1. Modeling on lower and upper forms, correction using the dust–free technique. 2. Color reinforcement of medium–length natural nails. Application Technology: 0. Prepare the nail plate for coverage: perform a manicure and shape the free edge of the nail. If using a remover, wipe off any residues with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (with PREPFINISH and a lint–free wipe. 2. Dehydration: apply NAIL FRESHER over the entire nail and let it air dry until a whitish hue appears on the nail surface. 3. Bonding: using a semi–dry brush, apply the acid–free primer ULTRABOND over the entire nail, retreating 1mm from the cuticle and sidewalls. Let air dry for 15 seconds. If using MULTI BASE, this step can be skipped. 4. Base Layer: apply a thin/rubbing layer of the MULTI/RUBBER BASE cushioning primer. Polymerize the base coating in a UV lamp for 2–3 minutes, or in a LED lamp for 60 seconds. 5. Modeling: prepare and place the form on each finger sequentially, applying a thin base of the desired length and shape directly onto the lower or upper template, retreating 1 mm from the cuticle. Model the nail architecture with the gel to create an arch; the gel can be pressed for 7–12 seconds, depending on the type and power of the lamp. Send the nail for complete polymerization of the gel for at least 60 seconds in a LED lamp or 3–4 minutes in a UV lamp. Remove any sticky residue with PREPFINISH, performing a step–by–step filing of the form and filing the natural nail from the inside by 1 mm. 6. Top Coat: secure the coating with a top coat. Polymerize in a UV lamp for 2–3 minutes, or in a LED lamp for 1 minute. If using a top coat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.