One Drop Gel for Nail Extensions

One Drop Gel No12 is a medium–thick camouflaging nail extension gel in a vacuum pump jar, featuring a soft rose tint. It is designed for extending, strengthening, and correcting the architecture of nails that are medium to long in length. This gel is used for: – Nail extensions on forms – Strengthening and correcting nail architecture both as a standalone product and in combination with firmer polymer materials. Advantages of One Drop Gel: convenient medium–thick consistency, cold polymerization, and natural shades. The primary benefit is excellent self–leveling. The gel has medium pigmentation and a natural hue that camouflages the transition from the natural nail to the artificial nail, adapting to the color of the nail plate. It is user–friendly and easy to store due to the vacuum dispensing system: one push equals one drop. The drop volume can be adjusted by the pressure applied to the pump. Hardness: high. Viscosity: medium. Plasticity: low. Density: medium. Pigmentation: medium. Note that the transparent silicone protective cap must be removed from the pump before use. Application technology: 0. Prepare the nail plate: perform a manicure and shape the free edge of the nail. 1. De–greasing: de–grease the nail plate mechanically (with a buffer) and chemically (using PREPFINISH and a lint–free wipe. 2. Dehydration: apply NAIL FRESHER to the entire nail and allow to air dry until a whitish tint appears on the surface. 3. Bonding: if using the PRO BASE–BOND adhesive base, skip this step. 4. Base coat: apply an even layer of PRO BASE–BOND base coat, thoroughly covering the sidewalls and free edge. Cure the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Strengthening: using a gel brush, apply a thin layer of gel over the entire surface of the nail, keeping a 1mm distance from the cuticle. Apply a second leveling layer on the uncured gel, following the basic principles of modeling with solid materials. Cure in a UV lamp for 2–4 minutes or in an LED lamp for 90 seconds. Remove residual stickiness with PREPFINISH and a lint–free wipe. Use a 150/180 grit file to shape the nail. PRO tips: – To make material application easier, you may use upper forms or gel tips. – To prevent lift from the free edge, it is recommended to file the natural nail from the inside by 1–2mm. Nail extensions: prepare/install forms one at a time for each finger. Apply a thin foundation of the desired length and shape directly on the lower or upper form and model the nail architecture using the gel. To create an arch, you can press the gel together at the 7–12 second mark, depending on the type and power of the lamp. Then, cure the nail under the lamp until the gel is fully polymerized for 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove residual stickiness with PREPFINISH and a lint–free wipe. Use a 150/180 grit file to shape the nail. PRO tip: apply the gel with a minimum 1mm distance from the cuticle to avoid material lift in this area.