One Drop Gel Pump Filler

Refill gel for nail extensions in a jar with a vacuum pump, One Drop Gel No12 – powdered rose One Drop Gel – a medium–thick camouflaging gel for nail extensions, strengthening, and correcting the architecture of medium to long nails. Used for: – extensions on tips and forms – strengthening and correcting nail architecture as a mono–product and in combined techniques with harder polymer materials. Advantages of One Drop Gel: convenient medium–thick consistency, cold polymerization, natural shades. The main advantage is the aesthetic appearance of the product throughout its use. Hardness: high. Viscosity: medium. Plasticity: low. Density: medium. Pigmentation: medium. Application technology: 0. Prepare the nail plate: perform a manicure, shape the free edge of the nail as desired. 1. Degreasing: mechanically (with a buffer) and chemically (with PREPFINISH and a lint–free wipe) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER to the entire nail, allowing it to air dry until a whitish tint appears on the surface. 3. Bonding: skip this step if using the PRO BASE–BOND adhesive base. 4. Base layer: apply a uniform layer of PRO BASE–BOND base coat, carefully edging the sidewalls and free edge. Cure the base coat in a UV lamp for 2–3 minutes, in an LED lamp for 60 seconds. 5. Strengthening: using a gel brush, apply a working layer of gel over the entire nail, leaving a 1mm gap from the cuticle. Apply a second leveling layer over the uncured gel, taking into account the basic principles of modeling with hard materials. Cure in a UV lamp for 2–4 minutes, in an LED lamp for 90 seconds. Remove the sticky residue with PREPFINISH and a lint–free wipe. Shape the surface using a 150/180 grits file in stages. PRO tips: – to ease material application, use tips or gel forms – to prevent lifting from the free edge, we recommend filing the natural nail from the inside by 1–2mm. Extension: prepare/set forms sequentially on each finger. Apply a thin base of the desired length and shape directly on the lower or upper form, then model the nail architecture with gel. To create an arch, you can hold the gel at the 7–12 second mark, depending on the lamp type and power. Next, place the nail in the lamp for complete gel polymerization for 60 seconds in an LED lamp, or 3–4 minutes in a UV lamp. Remove the sticky residue with PREPFINISH and a lint–free wipe. Shape the surface with a 150/180 file in stages. PRO tip: apply gel leaving at least 1mm away from the cuticle to avoid material lifting in this area.