COVER GEL Nail Extension Gel

TRANSPARENT GEL IN A JAR WITH A VACUUM PUMP COVER GEL No04 – COLD PINK Cover Gel is a classic medium camouflaging gel for strengthening and salon nail extensions to medium length. Used for: – Strengthening short nails with edge correction architecture in the no filing technique. – Salon form extensions of medium length. The gel has a consistency close to a base and controlled self–leveling, suitable for quick application. The semi–transparent natural shades gently camouflage the nail plate, creating an ideal base for French nails. Convenient to use and store, thanks to the vacuum dosing system: one press equals one drop. The drop volume can be adjusted by the pressure applied to the pump. Advantages of Cover Gel: – Medium viscosity allows for quick production line work. – Optimal viscosity self–levels smoothly, leaving minimal need for further refinement. – Semi–transparent finish creates an elegant Clean Girl effect. Hardness: 8/10 Density: 5/10 Viscosity: 4/10 Plasticity: 3/10 Pigmentation: 4/10 HOW TO APPLY THE GEL: 0. Prepare the nail plate: remove previous coverage, perform manicure, shape the nail tip as desired. 1. Degreasing: mechanically (using a 180/240 file) and chemically (using PrepFinish and a lint–free wipe) degrease the nail plate. 2. Dehydration: apply Nail Fresher to the entire nail, let it air dry until a whitish hue appears on the nail’s surface. 3. Bonding: skip this step if using the PRO Base–Bond adhesive base. 4. Base layer: apply an even layer of PRO Base–Bond base coat, carefully covering the sidewalls and free edge. Cure the base coat in an LED lamp for 60 seconds. For easier subsequent gel application, remove the sticky layer from the base. 5. 1. Strengthening: – using a gel brush, apply a thin layer of gel over the nail surface, leaving a 1. 5mm margin from the cuticle. – apply a second leveling layer over the uncured gel, following the main principles of modeling with liquid gels – cure in the LED lamp – 90 seconds on low power mode (24W) – remove remaining stickiness with PrepFinish and a lint–free wipe – use a 150/180 file to gradually shape the form – drill into the natural nail from the inside by at least 1mm using a drill bit or file. 5. 2. Extension: – prepare/set forms alternately on each finger – with a 1. 5mm margin from the cuticle area, layer a thin base of the desired length and shape directly on the lower or upper form, modeling the nail architecture with gel – cure in the LED lamp – 90 seconds on low power mode (24W) – remove remaining stickiness with PrepFinish and a lint–free wipe – use a 150/180 file to gradually shape the form. NOTE BEFORE USE: REMOVE THE TRANSPARENT PROTECTIVE CAP FROM THE PUMP.