One Drop Gel Pump Filler

Refill gel for nail extension in a jar with a vacuum pump, one Drop Gel No09 – milky–beige. One Drop Gel is a medium–thick camouflage gel for nail extension, strengthening, and correction for nails of medium to above medium length. It is used for: – extending on forms – strengthening and correcting the architecture of nails both as a standalone product and in combination techniques with harder polymer materials. One Drop Gel advantages include: convenient medium–thick consistency, cold polymerization, and natural shades. The main advantage is the aesthetic appearance of the product throughout its use. Hardness: high. Viscosity: medium. Plasticity: low. Density: medium. Pigmentation: medium. Application technology: 1. Nail preparation: perform a manicure and shape the free edge of the nail. 2. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (with PREPFINISH and a lint–free wipe. 3. Dehydration: apply NAIL FRESHER to the entire nail and let it air dry until a whitish hue appears on its surface. 4. Bonding: if using the PRO BASE–BOND adhesive base, skip this step. 5. Base layer: apply a uniform base coat of PRO BASE–BOND, carefully covering the sidewalls and free edge. Cure the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 6. Strengthening: use a gel brush to apply a rubbing layer of gel over the entire nail surface, leaving a 1mm gap from the cuticle. On the uncured gel, apply a second leveling layer, adhering to the key modeling principles with hard materials. Cure in a UV lamp for 2–4 minutes or in an LED lamp for 90 seconds. Remove any residue with PREPFINISH and a lint–free wipe. 7. Shape refinement: using a 150/180 grit file, perform a step–by–step shaping of the form. PRO tips: – to facilitate material application, consider using upper forms or gel tips. – to prevent lifting from the free edge, we recommend filing the natural nail from the inside by 1–2mm. Extension: prepare/install forms one by one on each finger. Apply a thin base layer of desired length and shape directly onto the lower or upper form, modeling the nail architecture with gel. To create an arch, you can pinch the gel at the 7–12 second mark, depending on the type and power of the lamp. Then, cure the nail in the lamp until the gel is fully polymerized: 60 seconds in an LED lamp, 3–4 minutes in a UV lamp. Remove any tackiness with PREPFINISH and a lint–free wipe. File in a step–by–step manner with a 150/180 grit file. PRO tip: apply gel with at least a 1mm gap from the cuticle to avoid material lifting in this area.