ULTRA GEL Nail Extension Gel

Color: blue Consistency: thick ADORE professional No06 color modeling gel for nails – gray–blue ULTRA GEL – is a medium–thick gel in vibrant shades for nail extensions and strengthening at salon length. The gel has a medium–density pigment and does not change color after polymerization. It has medium viscosity and quickly forms a drop when the nail is turned upside down. Highly adhesive. Does not shrink. Has no strong odor. Usage: 1. Forming with dual forms and correcting using the dust–free technique. 2. Color strengthening of medium–length natural nails. Application technology: 0. Prepare the nail plate for coating: perform a manicure and shape the free edge of the nail. If using a remover, wipe off any residue with a damp cloth. 1. Degreasing: mechanically (with a buff) and chemically (using PREPFINISH and a lint–free cloth) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER on the entire nail and allow to air dry until a whitish hue appears on the nail surface. 3. Bonding: with a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, staying 1mm away from the cuticle and side walls. Allow to air dry for 15 seconds; if using MULTI BASE, this step can be skipped. 4. Base coat: apply a thin/base layer of MULTI/RUBBER BASE. Cure in a UV lamp for 2–3 minutes, or in an LED lamp for 60 seconds. 5. Shaping: prepare and place the form alternately on each finger, laying a thin base of the desired length and shape on either the lower or upper template, staying 1mm from the cuticle. Model the nail architecture with gel to create the arch. The gel can be pressed on for 7–12 seconds, depending on the type and power of the lamp. Send the nail for complete gel polymerization for at least 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove the residual stickiness with PREPFINISH and perform a stepwise filing of the form, filing the natural nail from the inside by 1mm. 6. Top coat: secure with top coat. Cure in a UV lamp for 2–3 minutes, or in an LED lamp for 1 minute. If using a top coat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.