Ultrabond Acid-Free Primer

ULTRABOND Acid–Free Primer is a product that creates/improves adhesion between the natural nail surface and polymer material. It is used as the third step in preparing the nail plate in gel polish systems and systems for modeling and strengthening nails. It is applied after the dehydrator, before the base coat is applied. It is recommended for use with base materials that have medium to low acidity. For high–acid base coats, the use of primers should be avoided to prevent excessive adhesion (MULTI BASE, RUBBER BASE, or should be applied only to the most vulnerable areas to chipping (free edge. The product has a gentle effect on natural nails and has a neutral pH of 6. Application technology: 0. Prepare the nail plate for gel polish application: perform a manicure, shape the free edge of the nail as needed. If using a remover, remove any residue with a damp wipe. 1. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (using PREPFINISH and a lint–free wipe. 2. Dehydration: apply a thin layer of NAIL FRESHER over the entire nail surface; for humid hands, apply on the nail and sidewalls. Allow to air dry until a whitish tint appears on the nail plates surface. If necessary, repeat several times. 3. Bonding: with a semi–dry brush, apply ULTRABOND over the entire nail while leaving a 1mm margin from the cuticle and sidewalls. Try to apply the product in 1–2 strokes to avoid excessive adhesion, holding the brush at a 15–degree angle to the plate. Allow to air dry for 15 seconds. Use in designs: for sealing the edges of designs with pigments before applying topcoat to smooth out imperfections, and for slider designs before securing the design with the base.