Ultra Gel for Nail Extensions

Color: turquoise Consistency: thick Color modeling gel for nails ADORE professional No04 – soft mint ULTRA GEL – is a medium–thick gel in vivid shades for nail enhancement and strengthening to salon length. The gel has medium–density pigment and does not change color after polymerization. It has medium viscosity and flows quickly into a drop when the nail is inverted. Highly adhesive. It does not shrink. No strong odor. Usage: 1. Modeling on lower and upper forms, correction using a dust–free technique. 2. Color strengthening of natural nails of medium length. Application technique: 0. Prepare the nail plate for coating: perform a manicure and shape the free edge of the nail. If using a remover, wipe off the residue with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (using a buffer) and chemically (using PREPFINISH and a lint–free cloth. 2. Dehydration: apply NAIL FRESHER to the entire nail, allowing it to air dry until a whitish hue appears on the nail surface. 3. Bonding: apply acid–free primer ULTRABOND to the entire nail with a semi–dry brush, staying 1mm away from the cuticle and side walls. Let it air dry for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base layer: apply a thin/working layer of the cushioning base coat MULTI/RUBBER BASE. Polymerize the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying down a thin substrate of the desired length and shape directly on the lower or upper template, leaving 1mm from the cuticle to model the nail architecture with gel. The gel can be held in place for 7–12 seconds, depending on lamp type and power, ensuring the nail is fully polymerized for a minimum of 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove any residual stickiness with PREPFINISH, performing gradual filing of the form, and file the natural nail internally by 1mm. 6. Finish coat: secure the topcoat. Polymerize in a UV lamp for 2–3 minutes, in an LED lamp for 1 minute. If using a topcoat with a sticky layer RUBBER TOP – allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free cloth.