One Drop Gel Pump Filler

Color: white. Consistency: medium. One Drop Gel No06 refill for nail extension, stored in a vacuum pump jar, is milky with a pink undertone. One Drop Gel is a medium–thick camouflage gel for nail extension, reinforcement, and correction of nail architecture for medium and longer lengths. It is used for: – Extension on upper and lower forms – Reinforcement and correction of nail architecture as a mono–product and in combination techniques with harder polymer materials. Advantages of One Drop Gel: convenient medium–thick consistency, cold polymerization, natural shades. The main benefit is the aesthetic appearance of the product throughout its usage. Hardness: high. Viscosity: medium. Plasticity: low. Density: medium. Pigmentation: medium. Application technology: 0. Prepare the nail plate: perform a manicure and shape the free edge of the nail. 1. Degreasing: mechanically (with a buffer) and chemically (using PREPFINISH and a lint–free wipe) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER on the entire nail and let it air dry until a whitish tint appears on the surface. 3. Bonding: skip this step if using the adhesive base PRO BASE–BOND. 4. Base layer: apply an even primer layer of PRO BASE–BOND, carefully capping the sidewalls and free edge. Cure the base coat under a UV lamp for 2–3 minutes or under an LED lamp for 60 seconds. 5. Reinforcement: using a gel brush, apply a rubbing layer of gel over the entire surface of the nail plate with a 1mm margin from the cuticle. Apply a second leveling layer over the uncured gel, following the main principles of modeling with hard materials. Cure under a UV lamp for 2–4 minutes or under an LED lamp for 90 seconds. Remove remaining stickiness with PREPFINISH and a lint–free wipe. File with a 150/180 grit file to shape the form. PRO tips: – For easier material application, upper forms or gel tips can be used – To prevent lifting from the free edge, we recommend filing the natural nail from the inside by 1–2mm. For extension: prepare/install forms sequentially on each finger. Apply a thin base of the desired length and shape directly on the bottom or upper form, modeling the nail architecture with the gel. For creating an arch, press the gel on the 7th–12th second, depending on the type and power of the lamp. Then, cure the nail under the lamp until the gel is fully polymerized for 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove remaining stickiness with PREPFINISH and a lint–free wipe. File with a 150/180 grit file to create the desired form. PRO tip: apply the gel with a minimum 1mm margin from the cuticle to avoid material lifting in this area.