ULTRA GEL Nail Extension Gel

Color: Purple Consistency: Thick The ADORE Professional No01 Color Modeling Gel for Nails is a smoky lavender ULTRA GEL – a medium–thick gel in vibrant shades for nail extension and strengthening of salon length. The gel has a medium–density pigment that does not change color after polymerization. It has medium viscosity, quickly flows into a drop when the nail is turned upside down. Highly adhesive and does not shrink. No strong odor. Usage: 1. Modeling on forms (both lower and upper, correction using the dust–free technique. 2. Colored strengthening of natural nails of medium length. Application Technology: 0. Prepare the nail plate for coverage: perform a manicure, shape the free edge of the nail as needed. If using a remover, remove its residue with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (using a buff) and chemically (with PREPFINISH and a lint–free cloth. 2. Dehydration: apply NAIL FRESHER to the entire nail, allowing it to air dry until a whitish tint appears on the nail plate surface. 3. Bonding: apply the acid–free primer ULTRABOND to the entire nail with a semi–dry brush, keeping 1mm away from the cuticle and side walls. Allow it to air dry for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base coat: apply a thin layer of the MULTI/RUBBER BASE cushioning base coat. Polymerize the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying down a thin base of the desired length and shape directly on the lower or upper template with a 1mm space from the cuticle. Model the nail architecture with the gel to form an arch, and you can press the gel at the 7–12 second mark, depending on the lamp type and power. Send the nail for complete polymerization of the gel for a minimum of 60 seconds in an LED lamp or 3–4 minutes in a UV lamp. Remove the remaining stickiness using PREPFINISH and perform a step–by–step filing of the form, filing the natural nail from the inside by 1mm. 6. Finish coat: secure the finish with a top coat. Polymerize in a UV lamp for 2–3 minutes or in an LED lamp for 1 minute. If using a top coat with a sticky layer like RUBBER TOP, allow the coating to cool down, then remove the stickiness with PREPFINISH and a lint–free cloth.