ULTRA GEL Nail Extension Gel

Color: light blue. Consistency: thick. ADORE professional No06 color modeling gel for nails – gray–blue ULTRA GEL – is a medium–thick gel with bright shades for extending and strengthening salon–length nails. The gel has a medium density pigment and does not change color after polymerization. It has medium viscosity and quickly drips into a drop when the nail is turned upside down. Highly adhesive. No shrinkage. No strong odor. Usage: 1. Modeling on lower and upper forms, correction using the dust–free technique. 2. Color strengthening of natural nails of medium length. Application technology: 0. Prepare the nail plate for coverage: perform a manicure and shape the free edge of the nail as desired. If using a remover, remove residue with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (using PREPFINISH and lint–free wipes. 2. Dehydration: apply NAIL FRESHER to the entire nail and let it air dry until a whitish tint appears on the surface of the nail plate. 3. Bonding: with a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, leaving a 1mm distance from the cuticle and side walls. Let air dry for 15 seconds; this step can be skipped when using MULTI BASE. 4. Base coat: apply a grounding layer of the elastic base coat MULTI/RUBBER BASE in a thin/scrubbing layer. Polymerize the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying a thin substrate of the desired length and shape directly on the lower or upper template, leaving 1mm from the cuticle. Model the nail architecture with gel to create an arch; the gel can be pressed on the 7th–12th second, depending on the type and power of the lamp. Send the nail for full gel polymerization for at least 60 seconds in an LED lamp or for 3–4 minutes in a UV lamp. Remove residual stickiness with PREPFINISH and perform a step–by–step filing of the form, filing the natural nail from the inner side by 1mm. 6. Top coat: finish the coverage with a top coat. Polymerize in a UV lamp for 2–3 minutes or in an LED lamp for 1 minute. When using a top coat with a sticky layer RUBBER TOP, allow the coating to cool, then remove the stickiness with PREPFINISH and a lint–free wipe.