ULTRA GEL Nail Extension Gel

Color: Purple Consistency: Thick Color modeling gel for nails ADORE professional No02 – deep purple ULTRA GEL – medium–thick gel in bright shades for extending and strengthening salon–length nails. The gel has a dense pigment that does not change color after polymerization. It has medium viscosity and quickly pools into a droplet when the nail is turned over. Highly adhesive. Does not shrink. No strong odor. Usage: 1. Modeling on forms, correction using the dust–free technique. 2. Color reinforcement for medium–length natural nails. Application Technology: 0. Prepare the nail plate for coverage: perform a manicure, shape the free edge of the nail as needed. If using a remover, remove any residue with a damp wipe. 1. Degreasing: mechanically (using a buff) and chemically (using PREPFINISH and a lint–free wipe) degrease the nail plate. 2. Dehydration: apply NAIL FRESHER to the entire nail and allow to dry in the air until a whitish tint appears on the surface of the nail plate. 3. Bonding: using a semi–dry brush, apply acid–free primer ULTRABOND to the entire nail, staying 1mm away from the cuticle and side walls. Let it dry in the air for 15 seconds. When using MULTI BASE, this step can be skipped. 4. Base coat: apply a cushioning base coat MULTI/RUBBER BASE in a thin/rubbed layer. Polymerize the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying down a thin substrate of the desired length and shape directly on the lower or upper template, leaving 1 mm from the cuticle to model the nail architecture with gel to create an arch. The gel can be cured by placing it under a lamp for 7–12 seconds, depending on the type and power of the lamp. Send the nail for complete gel polymerization for 90 seconds in an LED lamp or 3–4 minutes in a UV lamp, then remove any remaining stickiness using PREPFINISH and perform incremental filing of the form, filing the natural nail from the inside by 1mm. 6. Top coat: secure the coating with a topcoat. Polymerize in a UV lamp for 2–3 minutes or in an LED lamp for 1 minute. If using a topcoat with a sticky layer RUBBER TOP, let the coating cool, then remove stickiness with PREPFINISH and a lint–free wipe.