ULTRA GEL Nail Extension Gel

Color: peach Consistency: thick The ADORE professional No03 colored modeling gel for nails is a soft peach ULTRA GEL–an average–thick gel in vibrant shades for extension and strengthening of salon–length nails. The gel has a medium–density pigment that does not change color after polymerization. It has medium viscosity, quickly pooling into a drop when the nail is turned upside down. Highly adhesive. Does not shrink. No strong odor. Usage: 1. Modeling on tip and form, correction using the dust–free technique. 2. Color strengthening of medium–length natural nails. Application technology: 0. Prepare the nail plate for coverage: perform a manicure and shape the free edge of the nail as needed. If using a remover, wipe off any residue with a damp cloth. 1. Degreasing: degrease the nail plate mechanically (with a buffer) and chemically (using PREPFINISH and a lint–free cloth. 2. Dehydration: apply NAIL FRESHER over the entire nail; allow to air dry until a whitish tint appears on the surface of the nail plate. 3. Bonding: with a semi–dry brush, apply the acid–free primer ULTRABOND to the entire nail, staying 1mm away from the cuticle and side walls. Allow to dry in the air for 15 seconds (this step can be skipped when using MULTI BASE. 4. Base layer: apply a thin/working layer of the cushioning base coat MULTI/RUBBER BASE. Polymerize the base coat in a UV lamp for 2–3 minutes or in an LED lamp for 60 seconds. 5. Modeling: prepare and place the form alternately on each finger, laying a thin base of the desired length and shape directly on the lower or upper template, leaving 1mm from the cuticle. Model the nail architecture with the gel to create an arch; the gel can be held for 7–12 seconds, depending on the type and power of the lamp. Send the nail for full gel polymerization for at least 60 seconds in an LED lamp or for 3–4 minutes in a UV lamp. Wipe off any remaining stickiness with PREPFINISH. Perform stepwise filing of the form, filing the natural nail internally by 1mm. 6. Finish coat: secure the coating with a top coat. Polymerize in a UV lamp for 2–3 minutes or in an LED lamp for 1 minute. If using a sticky top coat RUBBER TOP, allow the coating to cool and then remove the stickiness with PREPFINISH and a lint–free cloth.